Settings; Time Cooking; To Set Power Level; Sensor Settings - Kucht KMD24S User Manual

Drawer microwave
Hide thumbs Also See for KMD24S:
Table of Contents

Advertisement

Available languages

Available languages

SETTINGS

SETTINGS

TIME COOKING

Your Drawer Microwave can be programmed for 99 minutes
99 seconds (99.99). Always enter the seconds after the minutes,
even if they are both zeros.
• Cook for 5 minutes at 100%
1. Enter cooking time 5 0 0.
2. Touch Start /+ 1 Minute pad.

TO SET POWER LEVEL

There are eleven preset power levels.
Using lower power levels increases the cooking time, which
is recommended for foods such as cheese, milk and long slow
cooking of meats. Consult a microwave cookbook or recipes for
• Defrost for 5 minutes at 30%
1. Enter defrost time 5 0 0.
2. Touch Power Level 8 times.
3. Touch Start /+ 1 Minute.
TOUCH POWER
LEVEL PAD
NUMBER OF TIMES
FOR DESIRED
POWER
Power Level x 1
Power Level x 2
Power Level x 3
Power Level x 4
Power Level x 5
Power Level x 6
Power Level x 7
Power Level x 8
Power Level x 9
Power Level x 10
Power Level x 11
10
COMMON
APPROXIMATE
WORDS
PERCENTAGE
FOR POWER
OF POWER
LEVELS
100%
High
90%
80%
70%
Medium High
60%
50%
Medium
40%
30%
Med Low/Defrost
20%
10%
Low
0%

SENSOR SETTINGS

Sensor is a semi-conductor device that detects the vapor (moisture
and humidity) emitted from the food as it heats. The sensor
adjusts the cooking times and power levels for various foods
and quantities.
• After the oven is plugged in, wait 2 minutes before using
any sensor setting.
• Be sure the exterior of the cooking container and the interior
of the oven are dry. Wipe off any moisture with a dry cloth
or paper towel.
• The sensor works with foods at normal storage temperature.
For example, popcorn would be at room temperature.
• Any sensor selection can be programmed with More or Less
Time Adjustment. See page 16.
• More or less food than the quantity listed in the charts
should be cooked following the guidelines in any microwave
cookbook.
on the display. Do not open the oven or touch Stop/Clear
during this part of the cycle. The measurement of vapor will
be interrupted. If this occurs, an error message will appear.
To continue cooking, touch the Stop/Clear pad and cook
manually.
• When the sensor detects the vapor emitted from the food,
the remainder of cooking/reheating time will appear. The
oven may be opened when the remaining time appears on the
display. At this time, you may stir or season food, as desired.
• Except for Popcorn, if the sensor does not detect vapor
properly when cooking other foods,
and the microwave will turn off.
• Check food temperature after cooking. If additional time is
needed, continue to cook manually.
• Each food has a cooking hint. Touch the Set Up/Help pad
when the HELP indicator is lighted in the display.

COVERING FOODS

Some foods work best when covered. Use the cover recommended
in the charts for these foods. You may refer to the hints by
touching the Set Up/Help pad. See page 16.
• Casserole lid
• Plastic wrap: Use plastic wrap recommended for microwave
cooking. Cover dish loosely; allow approximately 1/2 inch
to remain uncovered to allow steam to escape. Plastic wrap
should not touch food.
• Wax paper: Cover dish completely. Fold excess wrap under
dish to secure. If dish is wider than paper, overlap two pieces
at least one inch to cover.
Be careful when removing any covering to allow steam to escape
away from you.
will be displayed,
ERROR
E

Advertisement

Table of Contents
loading

Table of Contents