Table of Contents
Advertisement
5.
Using the Quuppa Q17
5.1.
Installation
Quuppa Q17 should be mounted clear of any metal obstructions (such air-conditioning ducts, large
ceiling trusses, building superstructures) to the side or front of the enclosure. In case needed, use a
rigid conduit to lower the Quuppa Q17 away from these obstructions.
Install mounting bracket to the ceiling
The installation begins with the installation of the mounting bracket. The mounting bracket has several
holes for mounting screws. Use at least 4 screws to ensure a stable installation. The recommended
pattern is either VESA standard 75mm x 50mm or 50mm x 50mm which are both indicated on the
mounting bracket.
Ethernet cable can be pulled through the cable passage on the bracket, if there is a need to hide the
cabling.
The orientation indicator and orientation guideline in the mounting bracket may be used to align Quuppa
Q17 according to a defined orientation in the environment.
WARNING
Never attach, mount, or connect the mounting bracket to hot surfaces. Always
make sure that the surface can carry the weight of the equipment before
installation.
Not following general safety regulation can cause damage to objects or injuries to people. Rely on
qualified personnel for carrying out the installation of Quuppa Q17.
10/19
Quuppa Q17 Installation Guide and Safety Information
Quuppa Oy, Keilaranta 1, 02150 Espoo, Finland
© 2018 Quuppa Oy
Advertisement
Table of Contents
