Table of Contents
Advertisement
STEP 2
Installing the Driver & Software
12
Carefully guide the USB cable into the trench
as shown below, following the trench around
and toward the back of the machine. Then,
connect the cable to your computer.
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
• Make sure you use a USB 2.0 cable that is no
longer than 2 metres.
13
Lift the scanner cover to release the lock
Gently push the scanner cover support
down
18
and close the scanner cover
14
Turn on the machine by connecting the power
cord.
The installation of the Brother drivers will
automatically start. The installation screens
appear one after another. Please wait, it will
take a few seconds for all the screens to
appear.
Improper Setup
DO NOT try to cancel any of the screens during
this installation.
15
When the On-Line Registration screen is
displayed, make your selection and follow the
on-screen instructions.
.
.
®
Windows
Advertisement
Table of Contents
