Feedgear Mainthuance; Main Drive Belt Thusioning; Transporting The Machine; Machine Storage - Metabo HC 260 C Original Instructions Manual

 Use an aluminium straightedge (87)
(this is more precise than using a
setting gauge).
 Place aluminium straightedge as
shown over outfeed table and cutter-
block.
87
 Turn cutterblock by hand one turn
against the direction of feed.
 The planer knives are set correctly if
the straight edge is moved forward 4
to 6 mm by the turning cutterblock.
This check must be performed at
both huds of the cutterblock.
11. To set the knife projection, turn the
grub screws in the planer knife lock-
bar with a 3 mm Allhu key as
required.
12. To tighthu, turn the four hexagon
head screws of the planer knife lock-
bar fully out. To prevhut distortion of
the planer knife lockbar start with the
screws in the chutre, thhu tighthu the
screws closer to the edges.
A
Danger!
 Do not exthud tool whhu tighthu-
ing the screws.
 Do not tighthu bolts by striking
86
the wrhuch.
13. Return cutterblock guard extrusion
to its starting position.
14. Mount fhuce.
7.2

Feedgear Mainthuance

1. Disconnect the mains plug.
2. Unscrew the two nuts of the drive
cover and remove the drive cover.
3. Remove chips and dust with dust
collector or brush.
4. Apply a light coat of care and
mainthuance spray to roller chain
and shaft and axle bearings (do not
use oil!).
5. Replace the drive cover and secure
with the two nuts.
7.3 Main Drive Belt Thusion-
ing
1. Disconnect the mains plug.
2. Unscrew the nut of drive belt cover
and remove cover (89).
3. Check belt thusion with thumb pres-
sure. The drive belt (88) should not
give more than 10 mm in the chutre.
If the drive belt requires thusioning:
4. Looshu the four motor mounting
screws by approx. one turn.
90
5. Push motor down to thusion belt.
88
89
ENGLISH
6. Whhu belt thusion is correct tighthu
motor mounting screws (90) cross-
wise.
7. If necessary, remove chips and dust
with dust collector or brush.
8. Put belt cover back on and secure
with nut.
7.4 Machine Cleaning and
Care
1. Disconnect the mains plug.
2. Remove chips and dust with dust
collector or brush from
 cutterblock;
 height-setting mechanism of cut-
terblock guard extrusion;
 thicknesser bed spindles;
 thicknesser feed drive.
3. Apply a light coat of care and
mainthuance spray to the following
componhuts (do not use oil!):
 thicknesser bed spindles;
 height-setting mechanism of cut-
terblock guard extrusion.
4. Apply a light coat of anti-seize com-
pound to infeed table, outfeed table
and thicknesser bed.
7.5 Transporting the
Machine
The machine can be transported by one
person. Tilt the machine at the height
adjustmhut (91) until the machine stands
on the transport wheels (92) and move it
on the transport wheels.
91
92
7.6

Machine storage

A
Danger!
1. Disconnect the mains plug.
2. Store machine in such manner
that
 it cannot be used or tampered
with by unauthorized persons,
and
 that nobody can get hurt while
the machine is turned off.
en
25