Datalogic SKORPIO X5 Quick Start Manual page 4

FCC/IC LABELING
Handheld Variants Pistol Grip Variants
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause unde-
sired operation.
NOTICE:
This device is restricted to indoor use when operated in the 5.15 to 5.25 GHz frequency range.
Changes or modifications made to this equipment not expressly approved by Datalogic S.r.l. may
void the FCC authorization to
operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
y Reorient or relocate the receiving antenna.
y Increase the separation between the equipment and receiver.
y Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
y Consult the dealer or an experienced radio/TV technician for help.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter expect those approved under the filing.
For product available in the USA/Canada market, only channel 1~11 WLAN 2.4 GHz can be opera-
ted. No additional channels are supported in WLAN 2.4 GHz.
Federal Communication Commission (FCC) Radiation Exposure
Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ-
ment. End user must follow the specific operating instructions for satisfying RF exposure com-
pliance.
ISED COMPLIANCE
NOTICE:
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause unde-
sired operation.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est
autorisee aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouil-
lage est susceptible d'en compromettre
le fonctionnement.
CAUTION
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the poten-
tial for harmful interference to cochannel
mobile satellite systems;
(ii) high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-
5350MHz and 5650-5850 MHz and that
these radars could cause interference and/or damage to LE-LAN devices.
AVERTISSEMENT:
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont reserves uniquement pour une
utilisation a l'interieur afin de
reduire les risques de brouillage prejudiciable aux systemes de satellites mobiles utilisant les
memes canaux;
(ii) les utilisateurs de radars de haute puissance sont designes utilisateurs principaux (c.-a-d.,
qu'ils ont la priorite) pour les bandes 5
250-5 350 MHz et 5 650-5 850 MHz et que ces radars pourraient causer du brouillage et/ou des
dommages aux dispositifs LAN-EL.
CAN ICES-003 (B)/NMB-003(B)
Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être
exploités pour WLAN 2.4 GHz. La sélection d'autres canaux n'est pas possible.
RADIO TECHNOLOGIES AND FREQUENCY BANDS (USA AND
CANADA)
Radio Technology Frequency Band
2400 – 2462 MHz
5150 – 5350 MHz
WiFi
5470 – 5725MHz
5.735— 5.825 MHz
Bluetooth 2400 – 2483.5 MHz
RFID/NFC 13.56 MHz
RADIO FREQUENCY EXPOSURE INFORMATION
The SKORPIO X5 is designed to be held by the End User hands and carried close to the End User
body only using the belt holster accessory.
CAUTION: The device for operation in the band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile satellite
systems.
CE SAR COMPLIANCE
The Skorpio X5 complies with CE SAR limits for general population/uncontrolled exposure spe-
cified in Council Recommendation 1999/519/EC, ICNIRP Guidelines and RED (Directive 2014/53/
EU).
CE SAR Values
y Body-worn= 0,242 W/Kg at 10g (for body-worn use the device must be properly held in the
Datalogic genuine holster)
y Limbs=0,712 W/Kg at 10g
The Skorpio X5 has been tested for handheld and typical body-worn use (0mm distance from
the body, using a belt holster), according to EN 50360:2017, EN50566:2017, EN 62311: 2020, EN
50665:2017, EN 62479:2010, EN 50663:2017 and EN 62209-2:2010.
In order to meet the CE SAR Compliance, only genuine Datalogic Skorpio X5 Belt Holster must
be used. The use of third-party holsters (or similar accessories) may not comply with CE SAR
compliance requirements, thus should be avoided.
The genuine Datalogic belt holster must be properly worn, so that the Skorpio X5 faces to the end
user body its front (display) side or its back (battery) side. Refer to
Skorpio X5 genuine holster and accessories.
FCC/ISED SAR COMPLIANCE
The Skorpio X5 complies with the FCC SAR limits specified in the FCC 47 CFR part2 (2.1093) and
ANSI/IEEE C95.1-1992, and complies with the ISED SAR limits specified in ISED RSS-102 Issue
5 (2015).
FCC/ ISED SAR Values
y Body-worn= 1,19 W/Kg at 1g (for body-worn use the device must be properly held in the
Datalogic genuine holster)
y Limbs=1,98 W/Kg at 10g
The Skorpio X5 has been tested for handheld and typical body-worn use (0mm distance from the
body, using a belt holster), according to the specific SAR testing method referred at the Display
Exhibits section of https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm, filling the FCC IDs
specified in the FCC/IC labeling section of this Addendum.
In order to meet the FCC/ISED SAR Compliance, only genuine Datalogic Skorpio X5 Belt Holster
must be used. The use of third-party holsters (or similar accessories) may not comply with FCC/
ISED SAR compliance requirements, thus should be avoided.
The genuine Datalogic holster must be properly worn, so that the Skorpio X5 faces to the end
user body its front (display) side or its back (battery) side. Refer to
Skorpio X5 genuine holster and accessories.
Cet équipement peut être utilisé dans votres mains. Cet équipement peut être utilisé et installé
à une distance minimale de 0mm entre le radiateur et votres corps seulement avec le SKORPIO
X5 Belt Hoslter accessoire.
Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar
interferência em sistemas devidamente autorizados.
La operación de este equipo está sujeta a las siguientes dos condiciones.
1. Es posible que este equipo o dispositivo no cause interferencia perjudicial.
2. Este equipo o dispositivo debe aceptar cualquier interferencia. Incluyendo la que pueda causar
su operación no deseada.
微功率设备应当在其产品使用说明（含电子显示的说明书）中注明以下内容：
（一）符合"微功率短距离无线电发射设备目录和技术要求"的具体条款和使用场
景，采用的天线类型和性能，控制、调整及开关等使用方法；
（二）不得擅自改变使用场景或使用条件、扩大发射频率范围、加大发射功率（包括
额外加装射频功率放大器），不得擅自更改发射天线；
（三）不得对其他合法的无线电台（站）产生有害干扰，也不得提出免受有害干扰保
护；
（四）应当承受辐射射频能量的工业、科学及医疗（ISM）应用设备的干扰或其他合
法的无线电台（站）干扰；
（五）如对其他合法的无线电台（站）产生有害干扰时，应立即停止使用，并采取措
施消除干扰后方可继续使用；
（六）在航空器内和依据法律法规、国家有关规定、标准划设的射电天文台、气象雷
达站、卫星地球站（含测控、测距、接收、导航站）等军民用无线电台（站）、机场等的
电磁环境保护区域内使用微功率设备，应当遵守电磁环境保护及相关行业主管部门的规
定；
（七）禁止在以机场跑道中心点为圆心、半径5000米的区域内使用各类模型遥控器；
（八）微功率设备使用时温度和电压的环境条件。
https://www.datalogic.com for
https://www.datalogic.com for