Download Print this page
Thermaltake Extreme Spirit Il Instruction

Thermaltake Extreme Spirit Il Instruction

Advertisement

Quick Links

Extreme Spirit II
Extreme Spirit II
Application for all Northbridge chipsets
Components >>
Long screw x 2
Gasket gap pad x 1
Hooked screw x 2
Washer x 4
Standoff x 4
Before Installation >>
1.On Flip Chipset
Place the gasket gap pad onto the
Type 1: Flip chipset
heatsink as shown to prevent
crushing the chipset die.
2.On BGA Chipset
Type 2: BGA chipset. Please do not
use the gasket if you have this type
of chipset.
Please visit our Support Section for more technical support or update at
Northbridge Cooler
Northbridge Cooler
Application 1:
Northbridge chipset
with mounting holes.
Thermal grease x 1
Pass the screws through
the motherboard holes.
Pass the washers through the screws.
Place the Extreme Spirit II
over the chip and pass
the clips through the
screws.
P/N: CL-C0034
Long screw x 2
Pass washers through screws.
Standoff x 4
Washer x 4
Slip the washer on.
Slightly loosen the screw and pull out
the clips as shown in the picture.
Adjust the clips and Extreme Spirit II
to proper position.
1.
Secure the screws with the standoffs.
Secure the screws
by standoffs.
REVISION A.2006.03

Advertisement

loading
Need help?

Need help?

Do you have a question about the Extreme Spirit Il and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Thermaltake Extreme Spirit Il

  • Page 1 Extreme Spirit II Extreme Spirit II Northbridge Cooler Northbridge Cooler P/N: CL-C0034 Application for all Northbridge chipsets Application 1: Northbridge chipset Components >> with mounting holes. Long screw x 2 Pass washers through screws. Standoff x 4 Washer x 4 Long screw x 2 Gasket gap pad x 1 Thermal grease x 1...
  • Page 2 Extreme Spirit II Extreme Spirit II Northbridge Cooler Northbridge Cooler P/N: CL-C0034 Application for all Northbridge chipsets Fan Connection >> Application 2: Northbridge chip without mounting holes around. Slightly loosen the screws and pull out Hooked screw x 2 Plug the fan connector to the clips as shown in the picture.