Table of Contents
Advertisement
HANDEL
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 2 retainers attached to
each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the WARNING on the underside of
the base as shown above) To pass the SAFETY CORD through the HOLES for safety! Always ensure that the projector is firmly
anchored to avoid vibration and slipping whilst functioning. Always ensure that the structure that you are going to mount the projector
to is secure and strong enough to support the weight of the unit.
WARNING:
The projector MUST be lifted or carried by the HANDLES instead of clamps.
●
.For safety the safety cord should afford 10 times the Projector's weight.
●
POWER CONNECTION
●
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Before power connection, please ensure the power supplied must match what the nameplate says. It is recommended that each
projector be connected with power separately so that they may be individually switched on and off.
The earth wire(yellow/green) must be connected to the ground. And electrical connection
●
must be in accordance with the standards concerned.
If any questions about the electrical installation, do not continue but consult a qualified
●
electrician.
CLAMP
TO pass 2 SAFETY CORDS
through 4 HOLES for safety
CONTROL
PANEL
6
WARNING
HOLES for SAFETY CORDS
Advertisement
Table of Contents
