Master/Slave Mode; Operation Menu - PR -6000 Manual

"Enter" for the menu of Un-link Wireless under the upper level menu of Config Settigns , then the fixture is unlinked with the
wireless transmitter.
STAND-ALONE MODE
●
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within

MASTER/SLAVE MODE

●
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture's DMX output to the second fixture's DMX input using XLR-XLR control cable and then connect the second
fixture's DMX output to the third fixture's DMX input, and so on until all projector are connected in this way. Eventually connect the last
fixture's DMX output to a DMX terminator. Set 1
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master' and Slaves' operation mode can be
set accordingly.
After Powered on, the group will run in Master/Slave Mode
Master
DMX
Controler

6.OPERATION MENU

1st LEVEL 2nd LEVEL
DMX 地址
DMX Address
Address
IP Address
SubNet Mask
ArtNet Universe
Total Reset
Pan&Tilt Reset
Colour System Reset
Reset Gobo Reset
Dimmer/Strobe reset
Zo.Fo.Fr.Pr. Reset
Other Reset
DMX Channel Mode
Config Settings
Lamp Control
Signal Select
512.
st
projector as the master and others are Slaves.
Slave
3rd LEVEL
1-484 Short mode
1-480 Standard mode
1-473 Extend mode
Default IP Address
Custom IP Address
X.X.X.X
0-255
Really Reset?
Really Reset?
Really Reset?
Really Reset?
Really Reset?
Really Reset?
Really Reset?
Short Mode
Standard Mode
Extended Mode
View Selected Mode
Lamp Control
On By Power On
Control By DMX
Lamp Power
XLR Only
10
Slave
DMX
Terminator
4th LEVEL
2.X.X.X /10.X.X.X
X.X.X.X
OFF/ ON
OFF/ ON
OFF/ ON
1600/2000
5th LEVEL