Brother MFC-250C User Manual page 105

Error Message Cause
Not Registered You tried to access a Speed Dial
number that is not programmed.
The machine's memory is full.
Out of Memory
The memory card or USB Flash
memory drive you are using does
not have enough free space to scan
the documents.
Paper is jammed in the machine.
Paper Jam
Print Unable XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
Scan Unable XX
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Unusable Device A broken device has been
connected to the USB direct
interface.
A USB device or USB Flash
Unusable Device
memory drive that is not supported
Please Disconnect
has been connected to the USB
USB Device.
direct interface.
(For more information, visit us at
http://solutions.brother.com.)
Wrong Paper Size Paper is not the correct size.
Troubleshooting and Routine Maintenance
Action
Set up the Speed Dial number. (See Storing
Speed Dial numbers on page 45.)
When copy operation is in progress, press
Stop/Exit and wait until the other operations in
progress finish and then try again.
Delete unused files from your memory card or
USB Flash memory drive to make some free
space and then try again.
Remove the jammed paper by following the
steps in Printer jam or paper jam on page 97.
Make sure the paper length guide is adjusted to
the correct paper side.
Open the scanner cover and look on the left,
middle, and right hand side under the covers for
any foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power source for several
minutes then reconnect it.
Open the scanner cover and look on the left,
middle, and right hand side under the covers for
any foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power source for several
minutes then reconnect it.
Unplug the device from the USB direct interface,
then press On/Off to turn the machine off and
then on again.
Unplug the device from the USB direct interface.
Check that the machine's Paper Size setting
matches the size of paper in the tray. (See Paper
Size on page 19.)
B
95