Operation; Maintenance - ATD Tools ATD-7437A Owner's Manual

ASSEMBLY
is required.
manual for details in understanding the
the components of product.

MAINTENANCE

Important a good grade
different pes of fluid and NEVER use
tur ne oil, transmission fluid, motor oil or gl erin.
Improper fluid can cause premature failure of the
and the potential for sudden and immediate loss of load.
recommend
Adding oil
1. ith saddle f lowered, set
level position.
.
plug hole.
Changing oil
For performance and longest life, replace the
complete fluid at least once per
1. ith saddle f lowered, set
level position.
. the on its side and drain the fluid into a
container.
Note: Dispose of
local regulations.
3. Set in its level upright position.
4. Fill with oil until t
5. tall oil filler plug screw.
to the figures in the
oil. Avoid
e fluid,
13M or equivalent.
in its upright,
oil filler screw.
ar.
in its upright,
the oil filler screw.
fluid in accordance with
the rim of oil filler hole.

OPERATION

Raise saddle:
1. te and close release valve
e firml , then pump the pump handle until
the load is contacted.
Follow vehicle manufacturer's recommended proce-
dures for removing the load as outlined in vehicle
service manual or repair
on the saddle plate, resting against the angle plates.
3. Secure load with provided chains.
center of is centered on the saddle and load
is e e moving
Lower saddle:
Caution! sure all tools and personnel are clear
lowering load.
opening and closing the release valve as the
load is lowered. The resulting overload ma
cause
1. Slowl , turn the release valve
until the load is complet
. Immediatel transfer the load to an appropriate
repair
! WARNING
Lubrication
A periodic coating of light
and hinges will help to prevent rust and assure
that wheels, casters and pump
Cleaning
the ram for signs of rust or
corrosion. Clean as needed and wipe with an oil
cloth.
Note: Never use sandpaper or
these surfaces!
Storage
not in use, store the
saddle in lowest position.
IMPORTANT:
or detergent motor oil could damage the seals and result
3
turning no
.
loads are created
tem failure.
never more than 1/2 full turn
lowered.
To avoid crushing and related
on, under or
around a load supported onl
a
transfer the load to an
appropriate station.
ting oil to pivot points,
move freel .
rasive material on
with pump piston and