Installing Modules - Amana AKGD3060 Series Owner's Manual

Installing Modules

WARNING
To avoid risk of personal injury, all controls must be in
OFF position before removing or installing.
Burner Module
Burner module installs on both sides.
1. Turn controls to OFF position.
2. Remove grate and burner caps from module.
3. Place end of module into cooktop well with air
shutters facing rear of well.
• If grease pan from grill or griddle module is in
well, remove before installing burner module.
Front
4. Slide module towards rear of cooktop until module
engages cooktop. Lower front of module into well.
5. Place burner caps on burner base.
A
B
C
A—Burner grate
B—Burner cap
C—Burner base
Rear
Well
To make sure cap is properly aligned and leveled,
move burner cap around on burner base. Pegs in the
burner base fit into recess in underside of burner cap.
Burner cap must be correctly seated on burner base for
proper operation of burner.
Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap
is placed on burner base.
Not centered
6. Ignite burner. Properly adjusted burner flames are
clean and blue with a distinct inner cone
approximately ½ inch long.
• If burner flame is blowing or noisy, or if burner
flame is yellow and does not hold its shape, see
"Adjusting Burner Flame Characteristics" section.
7. Replace burner grate when flame is properly
adjusted.
12
Correct
Too small
Too large