Environmental Protection; Product Characteristics - BorMann BCD1005 Owner's Manual

Read the operating instruction
Use protective gloves
Rotation direction switch
Wear protective goggles
Wear hearing protectors

ENVIRONMENTAL PROTECTION

Correct disposal of this product: This marking shown on the product and its literature indicates this kind of product mustn't be
disposed with household wastes at the end of its working life in order to prevent possible harm to the environment or human
health. Therefore the customers is invited to supply to the correct disposal, differentiating this product from other types of
refusals and recycle it in responsible way, in order to re - use this components. The customer therefore is invited to contact the
local supplier office for the relative information to the differentiated collection and the recycling of this type of product

PRODUCT CHARACTERISTICS

Cordless screwdriver is a tool designed for screwing - unscrewing of various types of screws, bolts, nuts etc. by means of
replace-able screwdriver bits. Product has not been designed for economic activity. Correct, reliable and safe operation of the
product depends on proper operation, therefore:
Before starting the work with this tool, please read this manual and keep it properly.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and
recommendations specified in this manual.
EQUIPMENT
Factory packaging should contain the screwdriver and charger.
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries.
The notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire
tools and wireless ones.
INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapors.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapors.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters what so-ever in
order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk of an
electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the risk
of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and moving
elements. Damage to the power supply cable increases the risk of an electric shock.
In case work is realized outside closed areas, it is necessary to use extension cords designed for applications outside closed
areas. Using a correct extension cord permits to reduce the risk of an electric shock.
If operating a power tool in a damp location is unavoidable, use a residual current device (RDC) protected supply. Use of an
RCD reduces the risk of electric shock.
9
www.BormannTools.com