Operation; General; Maintenance; Daily Cleaning - Hatco Ultra-Glo UGFF Series Installation And Operating Manual

English

General

Use the following procedure to operate a Glo-Ray
Glo Portable Foodwarmers.
®
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Always operate unit with food pans installed.
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
2. Place empty food pans onto base.
3. Move the Power I/O (on/off) switch to the I (on) position.
• For units equipped with optional Infinite Switch, turn
control to desired setting.
• For GR-B models, move the I/O (on/off) rocker switch to
the I (on) position.
4. Allow 15–20 minutes for the unit to reach operating
temperature.
5. For models equipped with lights, flip the Power I/O (on/off)
Toggle Switch to the I (on) position or turn optional infinite
control to energize the lights.
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
General
Portable Foodwarmers are designed for maximum durability
and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord, and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
Form No. GRPM-1020
and Ultra-
®
CAUTION
CAUTION
NOTE: The unit comes equipped with an internal thermostat
that is factory preset. If an adjustment is necessary,
please consult factory.
Shutdown
1. Move the Power I/O (on/off) Switch to the O (off) position.
• For units equipped with optional Infinite Switch, turn
control to desired setting.
• For GR-B models, move the I/O (on/off) rocker switch to
the O (off) position.
Power I/O (on/off)
Control Panel (GR-B not shown)
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.

Daily Cleaning

To preserve the finish of the Foodwarmers, perform the
following cleaning procedure daily.
1. Turn off unit, unplug the power cord, and allow unit to cool.
2. Remove any accessories for proper cleaning in a
dishwasher or wash sink.
3. Wipe all metal surfaces with a damp, non-abrasive cloth.
Stubborn stains may be removed with a good, non-
abrasive cleaner. Clean hard to reach areas using a small
brush and mild soap.
4. Wipe dry the entire unit using a dry, non-abrasive cloth.
11

OPERATION

Toggle Switch
Infinite Control

MAINTENANCE

WARNING
NOTICE