D-Link DAP-3712 User Manual page 26

Section 3 - Configuration
Wireless Interface Settings
In this section, you can change the settings for the DAP-3712's Wi-Fi
operation mode, SSID, encryption, and site survey.
Scan Signal: When you click Scan Signal, the device will
conduct a site survey to find the SSIDs that the
DAP-3712 can detect. If you select an SSID, the
DAP-3712 will switch to client mode and connect
to the SSID you selected. Click the Edit button to
set up encryption (if required).
Rescan: Click this to perform a site survey again.
Select: Click this to select which SSID the DAP-3712 should
connect to.
Lock:
Use this to select which SSID and MAC address the
DAP-3712 should connect to. If you enable this, the
DAP-3712 will only connect to the AP you specify.
Cancel:
Click this to cancel the scan.
D-Link DAP-3712 User Manual 26