Electrolux ERT1000AOW User Manual page 6

6 www.electrolux.com
The climate classification can be found
on the serial plate, which is located at
the left on the inside of the appliance.
The appliance must be positioned so
that the plug is accessible. The following
table shows which ambient temperature
is correct for each climate classification:
Climate
classification
SN
ST
If the refrigeration appliance is installed
next to another refrigerator or freezer
a clearance of 5 cm at the sides is re-
quired, in order to prevent the formation
of condensation on the outside of the
appliance.
Your refrigerator needs air
For correct operation this appliance
must be located in a dry atmosphere,
away from heat sources, e.g. cookers,
radiators, boilers and direct sunlight.
You should also ensure that air can
circulate freely around the back and
the top of the cabinet. There should be
100mm between the top of the cabinet
and any overhanging kitchen furniture.
Alternatively allow 50mm between the
top of the cabinet and any overhanging
kitchen furniture and a gap of 25mm on
either side of the appliance.
Reversing the door
This refrigerator has the capability of
either opening the door from the left
or right side. This unit is delivered to
you with the door opening from the left
side. Should you desire to reverse the
opening direction, please follow these
instructions.
For an ambient
temperature
+10 to +32 ºC
N +16 to +32 ºC
+16 to +38 ºC
T +16 to +43 ºC
NOTE:
All parts removed must be saved
to do the reinstallation of the
door.
Reversal refrigerator door
1. Remove the screw nails (11).
2. Keep the door open, raise the end
of the top cover, push it(10) frontad
and take it off from the block(9) of
the top cover, then move the bottom
block(8).
3. Remove the two screws blot (6) that
connect the upper hinge (5) on the
right side of the cabinet top.
4. Carefully lift the door and place it
on a padded surface to prevent
scratching.
5. Remove the plug (7) and transfer it
to the uncovered hole on the right
side of the unit. Be sure to press the
button firmly into the hole.
6. Remove the two screws(6) that hold
the lower hinge (2) on the right side
of the unit.
7. Remove the screw-type leveling
front leg (4) and transfer it to the
right side as shown in the adjacent
figure.
8. Set the door into it's new place ma-
king sure the pin enters the bushing
at the lower frame section (hole).
9. Secure the upper hinge (5) pre-
viously removed in step 3 on the
left side of the unit. Make sure the
pin enters the bushing on the upper
frame section (hole).
10. Loosely secure the lower left hinge
(2) and do not tighten the bolts until
the door is in the closed position and
leveled.
11. Insert the plug (7) on the uncovered
holes (right side).
12. Fix the decoration block(8)in the
right of the top cover plate(10).
13. Keep the door open, raise the end of
the top cover, pull it(10) backwards
to hitch the block(9).
14. After the assembly of the top cover,
close the door, fix the top cover(10 )
with the screw(11).