Step Three:
A:Fix the Saddle (16) & Bracket (15)to Saddle Post (12) with Flat washer (14),Nylon nut (13) as pic
2-a/2-b shown.
BInsert the S
addle Post (12) into the post of Main Frame (1), and then fix with Knob (11) after adjusting to a
suitable height.
Step Four:
Insert the Handlebar Post Cover (36) into the Handlebar Post (34) and then connect Tension control
wire (37) well with the wires of Tension Controller (29) as picture A shown, finally connect the
Connecting wire (24) with the wire of Sensor (38).
Fix the Handlebar Post (34) on the post of the Main Frame (1) with Inner hexagon bolt (35), Spring
Washer (6) and Arc Washer (5) as shown. Finally, cover it with the Handlebar Post Cover (36).