Cablematic USB 3.0 DISPLAY ADAPTER User Manual page 9

USB 3.0 D A U M
ISPLAY DAPTER SER ANUAL
Step 6. H D D I (A )
ARDWARE EVICE RIVER NSTALLATION FTER REBOOT
Please connect the external display device (monitor/projector) to the VGA/DVI
connector of USB 3.0 D A and turn on this external display device.
ISPLAY DAPTER
Then plug the USB 3.0 D A into an available USB port of your PC or
ISPLAY DAPTER
Notebook. The device driver software setup will begin automatically.
After the driver is configured, you will see there an UI icon "USB Display
(Trigger) Utility " on the taskbar. The extended display will be shown on
the attached display device. You may begin to use the USB 3.0 Display
Adapter with your display device.
Step 7. I USB 3.0 D A
NSTALLATION OF MULTIPLE ISPLAY DAPTERS
Please plug in the additional USB 3.0 Display Adapter (connected with the external
display device already) to an available USB port of your computer (host PC), the
device driver will be configured automatically. After the driver is configured
completely, the USB extended display will be shown on the attached display device.
Repeat this step for each additional USB 3.0 Display Adapters you want to install.
All USB Display devices are now installed completely and ready to use.
※ The "USB Display (Trigger) Utility
" icon won't be appeared if the USB Display
Adapter does not connect to the USB host.
※ The screen may flash or go black during installation. It is part of the normal process.
9