Table of Contents
Advertisement
Available languages
Available languages
OPERATION / SETTINGS
SWITCHING ON / OFF
The mains voltage must correspond to the value specified on the
device nameplate.
Switching on – press the switch button (2) and hold it down.
Switching off – release the switch button (2).
Switch lock (continuous operation)
Switching on:
• Press the button switch (2), and then press the switch lock button
(3).
Switching off:
• Press and release the switch button (2).
BLOWING
• Attach the nozzle (5) to the blowing connector (1) and rotate it to
lock it in place (fig. A).
SUCTION
• Attach the nozzle (5) to the suction connector (4).
• Attach the dust bag (6) to the blowing connector (1) (fig. B).
After each use the dust bag must be emptied. Open the zip fastener of
the bag and empty its contents.
If the bag filling level is high, it will reduce the suction power.
CARE AND MAINTENANCE
Unplug the power cord from mains socket before commencing
any activities related to installation, adjustment, repair or
maintenance.
REPLACEMENT OF CARBON BRUSHES
Used (shorter than 5mm), burnt or broken motor carbon brushes
should be immediately replaced. Both carbon brushes should always
be replaced at the same time.
• Turn off the carbon brush plugs (7) (fig. C).
• Take out used carbon brushes and remove any carbon dust using
compressed air.
• Insert new carbon brushes. Carbon brushes should slide smoothly
into brush holders (fig. D).
• Fasten the carbon brush plugs (7).
When the carbon brushes are removed, the device should be
switched on for approximately 1-2 minutes, so that carbon
brushes fit the motor commutator. Carbon brushes should be
replaced only by a qualified person using original spare parts.
CLEANING
• It is recommended that you clean the device after each use.
• If possible, the motor housing should be always kept free from dust
and debris.
• Wipe the device with a clean cloth or blow it with low pressure
compressed air.
• Do not use water or chemical cleaning agents for cleaning.
• Be careful to prevent water from penetrating the device.
• When cleaning is completed, remove the dust bag, shake it and
clean thoroughly to prevent mould and odours.
• If very dirty, empty the dust bag, wash it in warm soapy water and
dry thoroughly.
• If the zip fastener is difficult to open, lubricate its teeth with soap.
MAINTENANCE AND STORAGE
• Make sure the screws are properly tightened to be able to work
safely.
• Use only original accessories and original spare parts.
• If the device is not used, it should be stored in a dry place, away
from children.
• In case of excessive sparking at commutator, have the condition of
• motor brushes checked by skilled personnel.
• If the power cord is damaged, replace it with another one which
• has the same characteristics. Entrust this operation to a qualified
technician or a repair shop.
All defects should be repaired by service workshop authorized by the
manufacturer.
TECHNICAL PARAMETERS
RATED PARAMETERS
Electric blower
Parameter
Supply voltage
Input current frequency
Rated power
Speed range
Air flow rate
Bag capacity
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp
= 86,9 dB(A) K = 2 dB(A)
A
Sound power: Lw
= 98 dB(A) (2000/14/EC)
A
Vibration acceleration: a
= 3,5 m/s
h
ENVIRONMENT PROTECTION
Do not dispose of electrically powered products with household
wastes, they should be utilized in proper plants. Obtain information
on wastes utilization from your seller or local authorities. Used up
electric and electronic equipment contains substances active in
natural environment. Unrecycled equipment constitutes a potential
risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa
with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa Topex) informs,
that all copyrights to this instruction (hereinafter Instruction), including, but not
limited to, text, photographies, schemes, drawings and layout of the instruction,
belong to Grupa Topex exclusively and are protected by laws accordingly to
Copyright and Related Rights Act of 4 February 2004 (ustawa o prawie autorskim
i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modifications for commercial purposes of the
entire Instruction or its parts without written permission of Grupa Topex are strictly
forbidden and may cause civil and legal liability.
11
Value
230 V AC
50 Hz
500 W
16000 min
-1
2,2 m³ / min
0,6 l
II
1,6 kg
2017
K=1,5 m/s
2
2
Advertisement
Table of Contents
