OEM FX Operating And Service Manual page 49

FX / RVE
Functioning
Chapter 5
5.1 - CONTROL BOARD AND SIGNALLING
LAMPS (Fig 1)
On the machine you can find following control
elements:
1. Timer
The timer has three positions:
"TIMER"
allows the machine manually to function, to start
the cycle press " " or "
concerned model, to stop the cycle press "
"0"
the machine functioning is disabled.
"Minute counter (1a)"
It is possible to set the machine functioning minu-
tes (from 0 to 30 minutes) by turning the timer knob
(1) clockwise, then press "
on the concerned model, to start the cycle; the
latter ends when the timer knob (1) reaches "0".
2. Green starting push-button "
enabled by turning the timer knob (1) on "TIMER"
or onto the minute counter.
If you press it, the machine starts.
3. Red stop push-button "
If you press it, the machine stops.
4. Green starting push-button "
(If any)
Enabled by positioning the timer knob (1) on
"TIMER"or on the minute counter.
If you press it, the machine starts.
", depending on the
".
" or " ", depending
" 1st speed.
"
" 2. speed.
Fig. 1
1
2
3
4
EN - 17