General Warnings - OEM FX Operating And Service Manual

Chapter 1

1.1 - GENERAL WARNINGS

- Before setting the machine at work the opera-
tor should have carefully red these instructions
and have acquired a deep knowledge of the
technical specifications and control devices.
- To the operator is suggested to attend a
training course on the use of the machine.
- Before installing the machine make sure that
the used area is compatible with the dimen-
sions and the weight of the machine.
- For the installation or removal of any machine
part, the used lifting and handling devices
should be suitable to the weight and geome-
trical characteristics of the part to be lifted or
handled.
- Only skilled and authorized personnel is
allowed to start adjust or repair the machine.
This handbook should be always consulted
before to do any work on the machine.
- Mechanical parts and electrical components
inside the machine are protected by totally
enclosed panels fastened with screws.
- Before cleaning and/or maintaining
machine and before removing any type of
protection, make sure that the general
switch is on "OFF" position (O), in order
to turn off the power while the operator is
working.
- The power supply system of the purchaser
should be provided with an automatic release
device above the machine main switch and
with a suitable earthling system complying
with the accident prevention regulations.
- In case of repairs to be done on the main
switch or in the main switch area, turn off the
power of the electrical line.
- Any inspection and maintenance works re-
quiring the removal of the safety protections
are made under the responsibility of the user.
Therefore it is recommended that the
above mentioned works are done by au-
thorized and skilled personnel only.
- Make sure that all safety devices (barriers,
protections, carter, micro-switches, etc.) have
not been tampered and are perfectly working.
On the contrary, they should be repaired.
EN - 2
- Do not remove the safety devices.
- In order to avoid personal risks, only suitable
tools should be used, in accordance with the
local safety regulations.
- Do not tamper the electric and pneumatic
plant or any other mechanism for any reason.
- Do not leave the machine unattended while
it is working.
- Wear safety clothing only, approved by the
law in force.
- In case of works to be done in a position that
cannot be reached from the ground, use safe
ladders or lifting devices only, in conformity
with the local safety regulations.
- In case of repairs to be done near or under
the machine, make sure that:
• there are no machine members that can
start working and/or instable parts placed
on the machine or near the machine.
- Do not use your hands instead of suitable
tools to work on the machine.
- Do not use your hands or other tools to stop
the
any moving parts.
- Do not use matches, lighters or flames near
the machine.
- YOUR BEST ATTENTION SHOULD BE
PAID TO THE WARNING PLATES LOCA-
TED ON THE MACHINE BEFORE DOING
ANY WORK ON THE MACHINE OR NEAR
THE MACHINE.
- The user is obliged to keep all the warning
plates in legible conditions and, if required, to
change their position in order to make them
fully visible to the operator.
- Moreover the user is obliged to replace any
warning plate that, for any reason, has been
damaged or is not clearly legible. New warning
plates can be obtained through our Technical
Service Centre.
- Stop the machine before doing any repair
work.
- In case of malfunction of the machine or da-
mages to its components, get in touch with
the maintenance engineer and do not try to
repair the machine.
FX / RB/ RVE
General specifications and warning