Realtree RTLS-503 Instruction & Safety Manual page 15

Installation Instructions Page 2
6
AA
O
Attach the Stabilizer Buckle
Strap to the Stabilizer Bar
AA
6
as shown below. Wrap the strap
around the back of the tree once
and secure the Buckle Strap
(See buckle & strap instructions)
9
X
DETAILED STABILIZER BAR AND BUCKLE STRAP INSTRUCTIONS
1
O
Place looped end of
1
Stabilizer Buckle
AA
Strap under the
Stabilizer Bar
DETAILED BUCKLE STRAP INSTRUCTIONS
1
Hold buckle as shown.
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
7
Cross Installation Straps
O behind tree. Attach to the top
7
rung of the bottom ladder section.
Pull to tighten the straps against
AA .
the tree. (See Installation Strap
Instructions).
Before sitting down IMMEDIATELY wrap the strap
9
of the Ratchet Strap
once and thread through the ratchet. (See Details
Ratchet Instructions Below).
W A R N I N G
2
O
AA
Insert Stabilizer
2
Buckle Strap
through loop and pull
O
. tight.
2
Press down on latch and
insert strap underneath
teeth as shown.
W
W
X
around the back of the tree
DO NOT climb ladder without Stabilizer Bar and Installation Straps installed. Serious
injury or death may occur if Stabilizer Bar and Installation Straps are not installed.
3
AA
AA
3
Place looped end of
AA Stabilizer Buckle
Strap AA
Stabilizer Bar
3
Pull strap to desired length.
15 Ft. Two-man Ladderstand
8
After the ladder stand has been
secured to the tree with the installation
straps, and the stabilizer bar has been
securely attached to the tree, continue
8
to have two people hold the ladder,
climb cautiously up to the platform.
Once you reach the top,
IMMEDIATELY ATTACH YOUR
SAFETY HARNESS TO THE TREE.
Keep the tether strap above our head.
4
O
AA
4
Insert Stabilizer
Buckle Strap
under the through loop and pull
O . tight.
4
Pull slack to tighten.
Model: RTLS-503
O
AA
AA
©2021 (rev. 1/21)