Programming Via Lan - Gira HomeServer 3 Commissioning Manual

4.4 Programming via LAN

You can transfer the changed data from the commissioning PC to the HomeServer when
both devices are connected to each other via a local network as follows:
1. Start the Expert software on your commissioning PC. Load the sample project with
the changed IP address (if required).
2. Select Transmit. A window Transmit Project now appears.
3. Select By Network.
4. Select Request HomeServer directly and enter the IP address and port number.
5. Enter User name (e. g. admin) and Password (e. g. admin) in the area User data
for registration at HomeServer.
6. Select Transmit data in the area Transmission mode.
7. Click on Start. The data are transferred via the network to the HomeServer.
8. Call up the sample project via your browser or the client program.
i
Note: Change of IP address in the HomeServer.
If the HomeServer has already been operated in a network with the IP address set at the
factory, but this address is later changed, then it may happen that the HomeServer is ini-
tially no longer recognized. In this case, switch off the HomeServer for a short time and
then switch it back on.
If the HomeServer is ready for operation then it signalizes this state by issuing three
double- beeps. Please note that it may take a few minutes until the entire network recog-
nizes the new IP address.
10.2006/V 1.0
HomeServer 3 - Commissioning
31