Advertisement
Always keep your marker pointed in a safe direction. Always use a barrel plug
or barrel blocking device. Always use ASTM approved paintball specific eye
protection in any areas where paintball markers may be discharged.
Remember that the ultimate safety device is you, the operator.
Safe Mode (all models)
In this manual, you will see the term "SAFE" mode. The Power should
be Off on Electronic Grips or the Safety should be set to "Safe" (red
marking on safety will not be visible - See figure 2). Make sure your
marker is set to "SAFE" mode when indicated to do so.
SAFETY OFF
SAFETY ON
4
APEX™ Barrel Installation
Make sure marker is degassed, hopper removed, no paintballs in the feed
port or breech and the marker is in "Safe" mode.
1. While pointing marker in a safe direction, place the threaded end of
the barrel into the front opening of the marker body. (See figure 3)
2. Turn the barrel clockwise until it stops (do not over tighten).
3. Adjust the barrel accessories if necessary.
4. Install a barrel blocking device. This can be a barrel plug or other such
device that prevents the accidental discharge of a paintball.
Figure 1
Figure 2
B T P A I N T B A L L . C O M
Figure 3
Advertisement
