Dell Latitude 5424 Rugged Service Manual page 123

4.
CAUTION: The following epoxy screw locations will require additional focus. These screws are difficult
to remove and there may be damage during the removal process. To prevent damage to the screws and
surrounding plastics, please use the correct screwdriver for each screw type.
Remove the four 'M2.5' epoxy screws securing the bezel to the back cover [1] and pry at bottom edge to separate the two
subassemblies [2].
5. Peel off the tape on the LCD connections [1] and open the connector [2] to disconnect the EDP cable [3] from the LCD.
6. Peel off the reflective tape [4] on the LCD panel and the touch connector [5] and disconnect the cable from the board [6].
Removing and installing components 123