Troubleshooting - Toro 22282 Series Operator's Manual

Troubleshooting

Perform only the steps described in these instructions. All further inspection, maintenance, and repair work
must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the
problem yourself.
Problem
The machine does not run or does not run
continuously.
The machine does not reach full power.
The machine or motor is producing
excessive vibration or noise.
The is an uneven cutting pattern.
The discharge chute plugs up.
The machine does not self-propel.
The machine is producing a beeping
sound.
Possible Cause
1. The battery is not fully installed in the
machine.
2. The battery pack is not charged.
3. The battery pack is damaged.
4. There is another electrical problem
with the machine.
1. The battery pack charge capacity is
too low.
2. The underside of the machine contains
clippings and debris.
1. The blade is bent or is out of balance.
2. The blade mounting nuts are loose.
3. The underside of the machine contains
clippings and debris.
4. The motor mounting bolts are loose.
1. All 4 wheels are not at the same height.
2. The blade is dull.
3. You are mowing in the same pattern
repeatedly.
4. The underside of the machine contains
clippings and debris.
1. The throttle lever is not in the F
position.
2. The cutting height is too low.
3. You are mowing too fast.
4. The grass is wet.
5. The underside of the machine contains
clippings and debris.
1. The self-propel drive cable is out of
adjustment or is damaged.
2. There is debris under the belt cover.
1. The battery pack is not charged.
2. The machine is in an unsafe position
for operation.
3. The machine is overloaded.
4. There is another electrical problem
with the machine.
27
Corrective Action
1. Remove and then replace the battery
into the machine, making sure that it is
fully installed and latched.
2. Remove the battery pack from the
machine and charge it.
3. Replace the battery pack.
4. Contact an Authorized Service Dealer.
1. Remove the battery pack from the
machine and fully charge the battery
pack.
2. Clean the underside of the machine.
1. Balance the blade. If the blade is bent,
replace it.
2. Tighten the blade mounting nuts.
3. Clean the underside of the machine.
4. Tighten the motor mounting bolts.
1. Place all 4 wheels at the same height.
2. Sharpen and balance the blade.
3. Change the mowing pattern.
4. Clean the underside of the machine.
1. Move the throttle lever to the F
AST
position.
2. Raise the cutting height.
3. Slow down.
4. Allow the grass to dry before mowing.
5. Clean the underside of the machine.
1. Adjust the self-propel drive cable.
Replace the cable if necessary.
2. Clean the debris from under the belt
cover.
1. Remove the battery pack from the
machine and charge it.
2. Ensure that the machine is not at an
extreme angle while operating.
3. Cut the grass at a higher height of cut
or walk at a slower pace while mowing.
4. Attempt the other troubleshooting
actions, if the alarm still sounds,
contact an Authorized Service Dealer.
AST