Brother DCP-193C User Manual page 73

Error Message
Cannot Print
Replace XX Ink
Cover is Open
Clean Unable XX
Close Ink Cover
Data Remaining
High Temperature
Hub is Unusable.
Init Unable XX
Ink Low Black
Ink Low Yellow
Ink Low Cyan
Ink Low Magenta
Low Temperature
Media Error
Media is Full.
No Cartridge
Cause
One or more of the ink cartridges
have reached the end of their life.
The machine will stop all print
operations.
The scanner cover is not closed
completely.
The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The print head is too warm.
A Hub or USB Flash memory
drive with a Hub has been
connected to the USB direct
interface.
The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
One or more of the ink cartridges
are running out of ink.
The print head is too cold.
The memory card is either
corrupted, incorrectly formatted,
or there is a problem with the
memory card.
The memory card or USB Flash
memory drive you are using
already contains 999 files.
An ink cartridge is not installed
correctly.
Troubleshooting and Routine Maintenance
Action
Replace the ink cartridges. (See Replacing
the ink cartridges on page 70.)
Lift the scanner cover and then close it
again.
Open the scanner cover and look inside
the machine for any foreign objects. If the
error message continues, disconnect the
machine from the power source for several
minutes and then reconnect it.
Firmly close the ink cartridge cover until it
clicks.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
Allow the machine to cool down.
A Hub or USB Flash memory drive with a
Hub are not supported. Unplug the device
from the USB direct interface.
Open the scanner cover and look inside
the machine for any foreign objects. If the
error message continues, disconnect the
machine from the power source for several
minutes and then reconnect it.
Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print.
Allow the machine to warm up.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive (slot)
of the machine by putting in another media
card that you know is working.
Your machine can only save to your
memory card or USB Flash memory drive
if it contains less than 999 files. Try
deleting unused files to free some space
and try again.
Take out the new ink cartridge and
re-install it slowly until it clicks. (See
Replacing the ink cartridges on page 70.)
B
65