Operate The Somnobutler 2 Stationary; Remove Devices; After Use - Weinmann SOMNObutler 2 stationary Description And Instructions For Use

5. Operate the
SOMNObutler 2 stationary
1. Disconnect the diagnosis device from the charging/data transfer cable at the start of
measurement.
For information on how to operate the individual components of the polysomnography
system, see the instructions for use for the components in question.

5.1 Remove devices

5.2 After use

1. Disconnect the cables, sensors, straps and electrodes
from the diagnosis device and the Transferbox 2.
2. Press the spring above Transferbox 2 into the device
platform.
3. Pull the Transferbox 2 up out of its bracket.
4. Pull the diagnosis device up out of its bracket.
1. Disconnect the cables, sensors, straps and electrodes
from the diagnosis device.
2. Hang the diagnosis device from the bracket for the
diagnosis device.
3. Connect the charging/data transfer cable to the
diagnosis device.
4. Hang the electrodes at the sides of the shelf.
5. Place loose cables and other small parts on the shelf.

Operate the SOMNObutler 2 stationary

23