Operation; Activating Preamp; Changing The Gain; Turning Off The Preamp - Jireh PREAMP CXA032 Manual

Chapter 6

OPERATION

6.1. Activating Preamp

1. Press the Mode Button to activate the preamp (Fig. 16).
2. The GAIN setting last selected will be become illuminated
indicating the preamp has been turned on (Fig. 17).
3. After 5 seconds, the selected GAIN setting LED will begin
blinking. (a measure to increase battery life)
Fig. 16 - Press the mode button to activate
TIP: When the battery has been replaced, the GAIN

6.2. Changing the GAIN

1. Press the Mode button to alternate between various
GAIN settings (Fig. 16).
TIP: When the preamp GAIN setting is blinking, an

6.3. Turning off the Preamp

1. Press and hold the mode button until the indicator lights
turns off. This confirms the preamp has been deactivated
(Fig. 16).
setting resets to 30 dB.
initial press of the power button is required to
activate the GAIN selection mode.
PAGE 15 of 24
Fig. 17 - GAIN light illuminates when power is on
CX0502 Rev 00.4