Water Supply - Blodgett SN-3E Specifications

SN-E CONVECTION STEAMER
SHORT FORM SPECIFICATIONS
Provide Blodgett model SN-3E (3 pan) or SN-5E (5 pan) countertop convection steamer with electric steam generator. Unit shall be constructed of satin finish 304 stainless steel with a
one piece welded 316 stainless steel cooking chamber with coved corners. The door shall have a removable inner liner of stainless steel with full perimeter gasket seal, an outer liner of
one-piece all welded stainless steel, and a positive lock and seal mechanism with spring release. The steamer shall have removable stainless steel pan supports and a stainless steel drip
trough integrally connected to collect and drain condensate when the door is open. The control housing shall be constructed of stainless steel with a full access removable panel. The con-
trols shall include an illuminated on/off/delime power switch, a ready indicator light, cooking indicator light, 60 minute electric timer with audible alarm that signals the end of the cook cycle,
and solid state generator controls. Steam flow shall be cut off when the door is opened during the cook cycle and shall be reactivated when the door is closed. Unit shall have a deliming
port located in the rear of unit. Provide options and accessories as indicated.

WATER SUPPLY:

Water quality is a major factor affecting the performance of your steamer. If
you are unsure of water quality, consult a local water treatment specialist and
have the water analyzed. Your water supply must be within these general
guidelines:
Total dissolved solids: Less than 60 PPM Total alkalinity: Less than 20 PPM
Silica: Less than 13 PPM Chlorine:
pH Factor: 7.0 - 8.5
Water which fails to meet these standards should be treated by installation of
a water conditioner. Failure or malfunction of this steamer due to poor water
quality is not covered under warranty.
WATER & DRAIN CONNECTIONS:
Drain 1-1/8"" (29mm) piped to open floor drain. No solid connec-
tion.
24" length before open air opening (no bends or elbows)
Cold Water 3/8" (10mm) tubing at 25-50 PSI (170-345 kPa)
POWER CONNECTION:
1-1/8"" (29mm) hole for electrical connection
NOTE: The company reserves the right to make substitutions of components without prior notice.
Printed in U.S.A.
Less than 1.5 PPM
44 Lakeside Avenue, Burlington, VT 05401
Toll Free: (800) 331-5842 • Phone: (802) 860-3700 • Fax: (802) 864-0183
NOTE: FOR COMMERCIAL USE ONLY
kW Phase 208V 220V 240V 380V 415V 480V 600V
1
7.5 kW
3
1
10 kW
Option
3
1
15 kW
3
MAXIMUM INPUT:
SN-3E 7.5 kW (10.0 kW option available)
SN-5E 15 kW
SHIPPING INFORMATION:
Approx. Weight:
SN-3E 170 lbs. (77 kg)
SN-5E 205 lbs. (93 kg)
BLODGETT
APPROVAL/STAMP
AMPS PER LINE
36 34 31 N/A N/A
21 20 18 11 10
48 46 42 N/A N/A
28 26 24 15 14
72 68 63 N/A N/A
42 39 36 23 21
P/N S00009 Rev G (12/06)
N/A N/A
9 7
N/A N/A
12 10
N/A N/A
18 14