Changing The Diaphragm - Zodiac X7 QUATTRO Instructions For Installation And Use Manual

Notice X7 ANG 2010.qxd 12/07/10

7 / Changing the Diaphragm

Figure 19
Figure 20
Figure 22
Figure 23
10:32 Page 11
2 2
•
1 st step: removing the Diaphragm
•
Place the X7 Quattro on a flat surface. Remove the small Flexi
Hose section by pressing the latches on either side of the hose
(see figure 12 page
•
Push the 2 clips maintaining the handle of the robot upwards
(Figure 19).
Figure 21
•
Extract the holder from its housing by pulling it upward
(Figure 22).
Figure 24
7).
•
Pull the the handle of the
robot downwards
•
Remove the case from its
holder (Figure 21)
it towards you.
•
Unscrew the holder
(Figure 23)
upper part.
•
Pull hard on the handle to
separate it from the holder
(Figure 24).
(Figure 20).
by pulling
and keep the