Table of Contents
Advertisement
Terrestrial reception
If you wish to receive also terresrtrial programmes,
connect the terrestrial aerial cable to the AERIAL
socket on the rear of the receiver. The signal for the
video recorder and the TV set is available at the
TV/VCR modulator output of the receiver.
Connection via the modulator
output
If your TV set or video recorder is not provided with
a EURO-AV socket, these sets are supplied via the
TV/VCR socket with the SAT signals. In this case, it
will be necessary to adjust the sets to each other. At
the factory, the modulator of the satellite receiver
has been preset to channel 37.
The following section describes how the TV set and
video recorder are tuned to the receiver.
Tuning the TV set and video
recorder to the receiver
This adjustment can be omitted if you have con-
nected the receiver via a EURO-AV connecting lead
to the television receiver or video recorder.
1
Press the
key and then the
.
control unit of the receiver. The receiver then will
send an on-screen display on channel 37.
2
Select a free channel position on your TV set and
tune to UHF channel 37 (the receiver's output chan-
nel). For this, refer to the instruction book of your TV
set. You will see the following on-screen display.
1
&
A
300
G
SU
G
20:14
GI
22:05
X
16:37
/ OK
3
If this channel is already being used by a TV chan-
nel or a different unit (say, your video recorder),
you will see interference if the other equipment is
operating.
Retune your TV to an unused part of its range
(channel number 28 to 47).
Turn the adjusting screw "CH. ADJ." on the back of
the receiver by means of a small screwdriver until
you see a picture.
Optimize the picture quality by finetuning your TV
4
set.
Tune in the same way a free programme position of
5
the video recorder to the receiver's ouptut channel.
How to connect your hifi system
Best sound quality is obtained when connecting the
receiver to hifi equipment.
On the AUDIO OUT L and R sockets only the sound
of the selected TV or radio programme of the tuner
A is provided.
1
Connect the AUDIO OUT L (left) and R (right)
sockets on the back of your receiver via a phono
(Cinch) cable (available from your dealer) to the hifi
amplifier.
1
key on the remote
WEEK 1
7
Advertisement
Table of Contents
