Switch Replacement - Sears CRAFTSMAN 572.826122 Owner's Manual

SWITCH REPLACEMENT

1. Unplug battery charger from wall outlet.
2. Disconnect both battery clamps from battery
terminals.
3. Unbolt black switch wire from battery clamp.
4. Unplug fuse holder in white wire; save fuse.
5. Make a note of tether length (see Figure 1) before
loosening cord clamp.
6. Remove cord from cord clamp and replace with new
cord. Make sure tether length is the same as the old
switch's tether.
7. Strip insulation off of white wire on new switch,
leaving 3/8" (9.5mm) bare wire exposed at the wire
end (see Figure 4).
8. Insert stripped wire end in small end of fuse holder
half; crimp holder onto wire and check crimp for
tightness (Figure 5).
NOTICE: Be sure that fuse holder half which you are
installing will mate with fuse holder half on pump
wire.
9. Insert fuse into holder and snap halves of housing
together (Figure 6).
10. Remount block on band and cord clamp assembly on
pump.
11. Strip black switch wire back 3/8" (9.5mm) from end of
wire. Crimp wire terminal onto end of wire and check
for tightness.
12. Bolt black switch wire onto battery terminal clamp.
13. Reinstall battery clamps:
A. Black switch wire clamps to positive battery
terminal.
B. Black pump wire clamps to negative battery
terminal.
NOTICE: DO NOT reverse terminal connections.
14. Turn pump upside down; unclip and remove screen.
Do not remove screw-mounted bottom plate. Lift
switch to momentarily "bump" pump. Check for
correct operation and rotation (pump must rotate
counter-clockwise when looking at end of shaft -
Figure 7). If not, reverse wires to battery and recheck.
15. Replace screen.
16. Plug in charger to wall outlet.
17. Fill sump with water and check switch action. Adjust
tether if necessary.
DO NOT test run pump for more than 5
seconds without water in it. Running pump dry for
extended periods could damage pump and voids
warranty.
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8 – Thread battery strap tie-down buckle as
shown
7
3340 1198