Download
Share
Print this page
Sears CRAFTSMAN 390.2505 Owner's Manual
  1. Manuals
  2. Brands
  3. Sears Manuals
  4. Water Pump
  5. CRAFTSMAN 390.2505
  6. Owner's manual

Sears CRAFTSMAN 390.2505 Owner's Manual

Shallow well jet pump
Hide thumbs

Advertisement

Quick Links

Download this manual
OWNER'S
MANUAL
MODEL NO.
390.2505
CAUTION:
Read and Follow
All Safety Rules and
Operating Instructions
Before First Use of
This Product.
Save This Manual For
Future Reference.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
PRINTED IN U.S.A.
SHALLOW WELL
JET PUMP
• Safety Instructions
• Installation
• Electrical
• Maintenance
• Repair Parts
®
Form No.
F642-04071
(8/3/04)

Advertisement

loading
Need help?

Need help?

Do you have a question about the CRAFTSMAN 390.2505 and is the answer not in the manual?

Questions and answers

Related Manuals for Sears CRAFTSMAN 390.2505

Summary of Contents for Sears CRAFTSMAN 390.2505

  • Page 1 Before First Use of • Safety Instructions This Product. • Installation Save This Manual For • Electrical Future Reference. • Maintenance • Repair Parts Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. PRINTED IN U.S.A. F642-04071 Form No. (8/3/04)

  • Page 2: Table Of Contents

    ® WELL PUMP For one year from the date of purchase, Sears will repair or replace this pump, free of charge, if defective in material or workmanship. This warranty does not cover repairs or replacement parts necessary because of abuse or negligence including failure to install, adjust and operate this pump according to the instructions in the owner’s manual.

  • Page 3: Major System Components

    (such as lights) that may be on the same circuit. A Shallow well jet pump can be installed on a dug well, drilled well or with a driven point. SEARS shallow well jet pumps have a built-in check valve. In a dug or cased well,...

  • Page 4: Installation

    INSTALLATION Pump Installation Relief Valve SEARS jet pumps can be used with Captive Air ® Tanks Priming Plug as shown in Figure 2. For mounting pump to tank, purchase tank fitting Kit To Household No. 2788. Water System Built-in Check Valve CRAFTSMAN Captive Air ®...

  • Page 5: Electrical

    ELECTRICAL Disconnect power before working on pump, motor, pressure switch, or wiring. Motor Switch Settings Dial Type Voltage Selector If the motor can operate at either 115 or 230 volts, it Power Supply Connections is set at the factory to 230 volts. Do not change motor voltage setting if line voltage is 230 volts, or if you have a single voltage motor.
  • Page 6 ELECTRICAL Wiring Connections Connection Procedure 1. Connect the ground wire first as shown in Figure 6. Fire hazard. Incorrect voltage can cause The ground wire must be a solid copper wire at least a fire or seriously damage the motor and voids the war- as large as the power supply wires.

  • Page 7: Maintenance

    MAINTENANCE Lubrication 3. Carefully tap diffuser to remove from seal plate. 4. Remove canopy from end of motor. It is not necessary to lubricate the pump or its motor. The motor has two ball bearings lubricated for life. The 5. Partially unscrew capacitor clamp; move capacitor mechanical shaft seal in the pump is water lubricated to one side.
  • Page 8 MAINTENANCE 4. Lubricate inside diameter and outer face of rubber HOW TO HANDLE drive ring with soapy water and slide assembly on A GASEOUS WELL motor shaft (sealing face first) until rubber drive In some localities well water contains gases which ring hits shaft shoulder.

  • Page 9: Troubleshooting

    TROUBLESHOOTING CHART SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Motor will not run 1. Disconnect switch is off 1. Be sure switch is on 2. Fuse is blown 2. Replace fuse 3. Starting switch is defective 3. Replace starting switch 4. Wires at motor are loose, 4.

  • Page 10: Repair Parts

    REPAIR PARTS 18 19 To Order Parts, Call Sears Product Service, 1-800-366-7278 2739 0197 SRS Model 390.2505 Qty. Part Number Used Description J218-953C Motor - 115/230V - 60 Cycle 17351-0009 Water Slinger N3-9 Seal Plate N20-35 Gasket - Seal Plate...
  • Page 11 REPAIR PARTS Shallow Well Jet Pump Air Volume Control Package For Use With Standard Air Tanks (Not Furnished - Must be purchased separately) Part Number Description 2761 Air Volume Control U78-774P Reducer Bushing - 1-1/4” x 1/4” NPT U37-17GPT Nipple - 1/4” x 1-1/2” U37-205P Tube - AVC U111-86T...
  • Page 12 9 am - 5 pm, Monday-Saturday 1-800-827-6655 1-800-827-6655 • Product Type • Model Number • Part Number REPAIR SERVICES REPAIR SERVICES • Part Description America's Repair Specialists America's Repair Specialists Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.