Immobilisation / Stabilisation / Lifting; Vehicle Stopping Operations - Volvo XC40 RECHARGE 2020 Emergency Response Manual

02. IMMOBILISATION / STABILISATION / LIFTING

Vehicle stopping
operations
For information of how to disconnect the traction
battery, please see section
HAZARDS / SAFETY REGULATION.
Crash
In the event of a collision, the Supple-
mental Restraint System (SRS)
module sends a signal to the Central
Electronic Module (CEM), stating
that a collision has occurred. In this
stage the vehicle assumes Crash mode. For safety
reasons, the vehicle has limited functionality.
Among other things, the contactors in the traction
battery are controlled to open and shut down
the high voltage outside the traction battery. The
passenger protection system like belt pretensioners
and airbags are activated.
Automatic activation of the parking
brake
The parking brake is activated automatically:
• if the car has entered Crash mode.
• if the driver unbuckles the seatbelt and/or
• opens the driver's door,
• when the vehicle is switched off manually in the
center display,
• if the function Hold (brake when stationary) is
activated and the vehicle has been stationary for
a while (approx. 10 minutes).
Shifting the gear position to parking
gear - P-mode
To shift the gear to P-mode, push the P-button
located next to the gear selector on the armrest
console. The vehicle must be at a standstill when
selecting the parking gear.
03 DISABLE DIRECT
i
NOTE
If the battery voltage is too low, the electrical
parking brake can neither be released nor
used.
When possible, always apply the parking
brake when the vehicle is standing in a slope.
Only putting the gear in P-position is not suf-
ficient to stop the car. Turn off and stabilize
vehicle
Automatic deactivation of the
vehicle
The vehicle is switched off automati-
cally from drive mode if the vehicle
has entered Crash mode or when the
driver leaves the vehicle and it is
parked.
1. Activate the parking brake.
2. Open the driver's door.
> The vehicle is now not in Drive mode.
Manual deactivation of the vehicle
It is possible to switch off the vehicle manually.
1. Activate the parking brake.
2. Press the symbol
3. Press Controls.
4. Select Power off car.
> The vehicle is now not in Drive mode.
12
.