Display P-Codes (Programming Codes); To Access This Menu - Ningbo VSETT 8 User Manual

Vsett display operation and programming

Display P-Codes (Programming codes)

To access this menu, long-press and . Use button to scroll through P-codes, and to change parameters.
P01：Backlight brightness:The 1 level is the darkest，Level 3 brightest；Default: 3
P02：Mileage: unit,0：KM；1：MILE；Default: KM
P03: Voltage level: 24V，36V，48V，52V，60V.
P04: Dormancy time:0 means no dormancy;Other numbers are dormant time.The range is 1-60 minute.Default:5
P05: Reserve
P06: Wheel diameter: The unit is inch. The accuracy is 0.1; Default:10.0
P07: Speed measuring magnetic steel number.The range is 0-255. Default:28
P08: Rate-limiting: The range is 0-100km/h.Default: 100
P09: Zero start、no zero start setting；0 means zero start.1means no Zero start.Default: 0
P10:Reserve
P11: EABS switch choose.The range is 1-5.0 means closing.1 means weakest.2 means strongest.
P12: Soft and hard start strength.The range is 1-5. The softest is 1.The hardest is5.Default: 3
P13: Reserve
P14: Reserve
P15: Controller under-voltage
P16: ODO Zero setting: keep pressing + for 5 seconds,ODO will zero clearing.
P17: When it shows 0,it can not use cruise.When it shows 1,it can use cruise.Default:0
P18: Bind and unbind NFC CARDS.Long press "+" to build the binding, long press "-" to build the unbinding
P19: Reserve
P20: Communication protocol is defaults 4.It can not change.
Vsett display operation and programming