Points In Operation And How To Stop - Makita EM3400U Instruction Manual

POINTS IN OPERATION AND HOW TO STOP

CAUTION : Observe the applicable accident prevention regulations!
STARTING
WARNING: Pay attention that the cutting tool rotates immediately after engine starts. Make sure that the cutting tool has no contact with hard
objects such as branches, stones etc.
CAUTION:
– Move at least 3 m away from the place of refuelling. Place the unit on the ground taking care that the cutting tool does not come into contact
with the ground or any other objects.
– Never pull the rope to the full extension. Once the starter knob is pulled, never release your hand immediately. Hold the starter knob until it
returns to its original point.
A: Cold start
1) Set this machine on a flat space.
2) Grasp the handle (the safety lock-off (1) is
released by the grasp).
3) Press the throttle lever (2) and hold it down.
4) Slide the I-O switch (3) to START (4). It
makes the throttle lever become half-throttle
lock state.
5) Give a gentle push on the primer pump (5) repeatedly (7-10 times) until fuel
comes into the primer pump.
6) Move the choke lever (6) to the top position (
7) Firmly hold the unit by your left hand.
8) Pull the starter knob gently until feeling compression. Then pull it strongly.
9) Repeat the starting operation until initial ignitions are heard.
10) When the engine starts, return the choke lever to "
position.
11) As soon as the engine starts, immediately grasp the handle (the safety
lock-off is released by the grasp) and pull the throttle trigger for a little, and
release it. (It releases the half-throttle lock state and the engine runs in idle.)
12) Run the engine for approximately one minute at moderate speed before
applying full throttle.
B: Warm start
– Same as described above, except without moving the choke lever (choke lever remains "
NOTE:
In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Also,dry the electrode
section of the spark plug.
Caution during operation: If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min
Never operate the engine at higher speed than required. Operate the engine at an approximate speed of 6,000 - 8,000 min
(2)
- closed choke).
- open choke"
14
(4)
(3)
(4)
(1)
EM3400U
EM3400UG
(5)
- open choke" position).
(1)
(2)
(3)
EM3400L
EM3400LG
(6)
or more.
-1
.
-1