Note
• If using an electric screwdriver, set the torque at
approximately 1.5 N·m {15 kgf·cm}.
• Be sure to fasten the Wall-Mount Attachment
when attaching them to the LCD Display.
Use only a flat head screwdriver to install the
Wall-Mount Attachment. Use of another tool
might result in over torqueing the Wall-Mount
Attachment and damaging the LCD Display.
Detaching the Table-Top Stand from the
LCD Display
1
Remove one side of the Table-Top
Stand at a time. Firmly hold the
Table-Top Stand securely with both
hands while the other people lift up
the LCD Display.
2
Repeat the previous step and
remove the other side of the
Table-Top Stand.
Note
• Three or more people are required to detach the
Table-Top Stand.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the LCD
Display as it may cause the LCD Display to fall
resulting in personal injury or physical damage
to the LCD Display.
• Take care when handling the Table-Top Stand to
prevent damage to the LCD Display.
• Be careful when lifting the LCD Display as the
Table-Top Stand is detached, the Table-Top
Stand may topple over and cause personal
injury.
• Take care when removing the Table-Top Stand
from the LCD Display to prevent it from falling
over and damaging the surface that the LCD
Display is sitting on.
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the LCD Display.
• Be sure the LCD Display is vertical before turning
on. To avoid uneven picture uniformity do not
power on the LCD Display with the LCD panel
facing down.
US
17
US