Gecko Aqua-Flo Flo-Master XP3 Quick Manual

basic safety precautions should always be followed, including the following:
READ & FOLLOW ALL INSTRUCTIONS
WARNING
This equipment is to be installed in accordance with the "Nation-
al Wiring Rules" by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
If the supply cord is damaged, it must be replaced by the manu-
facturer, its service agent or similarly qualified persons in order to
avoid a hazard.
Turn the power OFF before servicing or modifying any cable
connections in this unit.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
The pump is to be supplied via an isolating transformer or
supplied through a residual current Device (RCD) having a rated
Aqua-Flo by Gecko
pumps for small to swim spas
Flo-Master ® XP3, Flo-Master

IMPORTANT SAFETY INSTRUCTIONS

When installing and using this electrical equipment,
SAVE THESE INSTRUCTIONS
going strongly against the flow
® XP2e, Flo-Master ® XP2, Circ-Master HP/CP/XP
residual operating current not exceeding 30mA. Such a RCD
should be provided by the installer and should be tested on a
routine basis.
To test the RCD, push the test button. The RCD should interrupt
power. Rearm the lever. Power should be restored.
If the RCD fails to operate in this manner, the RCD is defective.
If the RCD interrupts power to the pump without the test button
being pushed, a ground current is flowing, indicating the possibil-
ity of an electric shock. Do not use this pump. Disconnect the
pump and have the problem corrected by a qualified service
representative before using.
This pump is for use with permanently-installed pools and may
also be used with hot tubs and spas if so marked. Do not use with
storable pools.
A permanently-installed pool is constructed in or on the ground or
in a building such that it cannot be readily disassembled for
storage.
A storable pool is constructed so that it is capable of being readily
disassembled for storage and reassembled to its original integrity.
pumps for small to swim spas
•••
CAUTION