Gecko Aqua-Flo Therma-Flo Enviro-Heat Series Owner's Manual

Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Aqua-Flo Therma-Flo Enviro-Heat Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Gecko Aqua-Flo Therma-Flo Enviro-Heat Series

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. WARNING: When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: READ AND FOLLOW ALL INSTRUCTIONS. 2.) DANGER : To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times.
  • Page 3: Installation Instructions

    Therma-Flo Series Pumps INSTALLATION INSTRUCTIONS WARNING: WHEN USING ELECTRICAL PRODUCTS, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: 1. DANGER: RISK OF ELECTRICAL SHOCK. Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a qualified service representative and grounded.
  • Page 4 Disc harge plumbing slightly angled to bleed air. Suc tion plu mbin g sli ghtly an gled to e nabl e water to dra in out from pump when switched off. 2. This pump is intended for permanent installation only and must not be used in portable service application.
  • Page 5 INSTALLATION WARNINGS (MAY CAUSE SERIOUS INJURIES OR DEATH) • The power supply must be turned off during the installation process. • This pump is wired for 115 VAC, 60 Hz, and Single Phase power supply only. The power supply should be supplied through a Ground Fault Circuit Interrupter (GFCI) with a rated tripping current not exceeding 5 mA.
  • Page 6 OPERATING & MAINTENANCE INSTRUCTIONS INITIAL START-UP WARNINGS (MAY CAUSE SERIOUS INJURIES OR DEATH) • This pump is wired for 115 VAC, 60 Hz, and Single Phase power supply ONLY. The power supply should be supplied through a Ground Fault Circuit Interrupter (GFCI) with a rated tripping current not exceeding 5 mA.
  • Page 7: Troubleshooting

    CAUTION (MAY CAUSE PROPERTY DAMAGE) • DO NOT open or service the pump. There are no “user servicable” parts or assemblies inside. This pump contains dielectric oil used to cool down the motor. The amount of oil contained herein was precisely measured for optimum performance.

Table of Contents