Operation; Maintenance; Optional Accessories - Makita 6807 Instruction Manual

Speed change knob
Fig.6
Two rpm ranges can be preselected with the speed
change knob.
For low speed range (0 - 1,000/min.), turn the knob so
that the pointer points to the number 1 marked on the
knob.
For high speed range (0 - 2,200/min.), turn the knob so
that the pointer points to the number 2.
If it is hard to turn the knob, pull the switch trigger
half-way for running the tool at low speed and turn the
knob again.
CAUTION:
Do not turn the knob while the tool is running at full
•
speed. Malfunction of the tool may result.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing the bit
To remove the bit, first pull the locator out of the locking
sleeve. Then grasp the bit with a pair of pliers and pull the
bit out of the magnetic bit holder. Sometimes, it helps to
wiggle the bit with the pliers as you pull.
Fig.7
To install the bit, push it firmly into the magnetic bit holder.
Then install the locator by pushing it firmly back onto the
locking sleeve.
Fig.8

OPERATION

Always use the side grip (auxiliary handle) and firmly
hold the tool by both side grip and switch handle during
operations.
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
When fitting the screw onto the point of the bit, be
•
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
Make sure that the bit is inserted straight in the
•
screw head, or the screw and/or bit may be
damaged.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Phillips bits
•
Magnetic bit holder
•
Magnetic socket bit
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
5
or attachments
Only use accessory or
are