Advertisement
Compact Series
MODEL
ODD-100MS + LED
INSTALLATION GUIDE
Assembly Instructions
(for LED Light Grille with Motion Sensor)
Retrofit Installation
info@ortechindustries.com
www.ortechindustries.com
1. Remove the wire panel, insert the light wire into wire panel, and connect electrical wiring.
Refer to the WIRING DIAGRAM on the next page when installing the wire panel
2. Insert the plug from the control box and LED light grille assembly into the suitable wire panel
3. Insert the plug from the sensor system into the control box
4. Install Grille Assembly to the fan
1. Remove wire panel and blower assembly before installation
2. Fold mounting ears flat against housing
3. Enlarge ceiling opening to 9-1/2" by 9-1/2", leave ductwork
4. Connect wiring according to the wiring diagram on the next
5. Mounting fan:
6. Connect duct:
7. Install the blower assembly
13376 Comber Way
Surrey BC V3W 5V9
and wiring in place
page of this manual. Re-install wire panel
a) Mount with additional mounting holes:
The interior of the fan housing contains additional
mounting holes in case exterior mounting is not possible.
Screw or nail the fan housing directly to the framing or
joists. Remove the blower assembly as directed in the
service parts of the very last page of the manual to gain
access to the additional mounting holes
b) Mount with Hole of the Flange:
Use screws (included) to screw fans to the ceiling through
the holes of the housing
Pull existing ducting through housing discharge opening and
tape ducting to duct connector. Push connector / ducting back
through opening, fix the duct by the tab
375 Admiral Blvd
Mississauga
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474
Advertisement
