Advertisement
Unpacking
Carefully lift unit out of shipping container, and inspect
immediately for shipping damage. Your Ground Coffee
Dispenser was shipped in a carton designed to give it
Cleaning Instructions
Disassemble
1. Remove the two knurled screws on the front of
dispenser.
2. Lift up on pull knob shaft and remove the plate
assembly.
3. Remove hopper cover. Pull lock spring knob out
located on backside of dispenser. At the same
time, lift hopper up from the rear.
4. Remove slide assembly and trap door.
Cleaning
1. Hand wash in mild soap and warm water.
2. Rinse and dry thoroughly before re-assembling.
Adjustments
1. Remove thumb screws and top cover.
3. Pull the knob on the back of
the dispenser.
2
maximum protection. It was thoroughly inspected
before leaving the factory. File any claims for shipping
damage or irregularities directly with the carrier.
To reassemble
1. Place trap door in position.
2. Place slide into hopper assembly.
3. Place hopper in dispenser cabinet by holding
hopper higher in the back so the groove on
front side of hopper can slide into position on
cabinet.
4. Press hopper down firmly on back of cabinet.
Pull lock spring knob out so lock spring can snap
into location. You should be able to hear the
lock click.
5. Place pull rod in slot located on the slide and
replace the two front panel screws.
6. Cabinet can be cleaned with a mild soap and a
damp cloth. AVOID excess water.
2. Lift dispense handle up and pull straight out.
Tilt the hopper forward.
Cecilware
®
Pull assembly straight up.
AL-LEN™ Ground Coffee Dispenser
Advertisement
