Table of Contents
Advertisement
Problem
Possible Cause
A layer of frost
Blocked air outlets.
occurs in the
Insufficient ventilation.
compartment
Door not closed.
Temperature inside
Door(s) open too long /
is too warm
too frequently
Temperature inside
Temperature needs
is too cold
adjusting.
Doors can't be
Obstruction.
closed easily
The water pan (located
at the rear bottom of the
appliance) may not be
properly levelled, or the
draining spout ( located
Water drips on the
underneath the top of the
floor
compressor depot) may
not be properly positioned
to direct water into this
pan, or the water spout is
blocked
The LED light my be
damaged.
The light is not
The control system has
working
disabled the lights due to
the door being kept open
too long.
Fault Display
Error Code
UC
RS
CS
FS
Fd
FF
ES
FH
Solution
Check that the air outlets are not blocked by food and ensure food is
placed within the appliance to allow sufficient ventilation.
Ensure that door is fully closed.
To remove the frost, please refer to cleaning and maintenance chapter.
Check the door(s) are closed properly.
Ensure the clearance at the sides, back and top of the appliance is
sufficient.
Increase the temperature by following the "Setting the Fridge
Temperature" section in the "Overview" chapter .
Check whether the top of the refrigerator is tilted back by 10-15mm to
allow the doors to self close, or if something inside is preventing the
doors from closing.
You may need to pull the refrigerator away from the wall to check the
pan and spout.
Refer to replace LED lights in cleaning and maintenance chapter.
Close and re-open the door to re-activate the light.
Error Type
Communication failure or model mismatch
Sensor failure (refrigerating chamber)
Sensor failure (Drinks box)
Sensor failure (freezing chamber)
Defrosting sensor failure
Fan failure
Failure of ambient temperature sensor
Defrosting failure
17
Advertisement
Table of Contents
