Table of Contents
Advertisement
Connecting the speaker cables
1.
Remove approximately 10 mm of insulation from the end of each speaker cable.
Then, twist the bare wires of the cable firmly together.
2.
Unscrew the knob.
3.
Insert one bare wire into the hole in the side of each terminal.
4.
Tighten the knob to secure the wire.
+ (red)
- (black)
When connecting the speaker cable, take notice of the followings:
• Do not let the bare wires of the speaker cable touch one another.
• Do not let the bare wires of the speaker cable come into contact
with MAESTRO's rear panel and screws.
Using a banana plug
1.
Tighten the knob.
2.
Insert the banana plug into the end of the terminal.
Banana plug
© sonoro audio GmbH 2019
GB
91
Advertisement
Table of Contents
