Advertisement
Please see
™
AquaBasin
Ultra
Pump Kit Instructions
for assembly steps
of pump and plumbing.
Installing a
Stone Fountain
™
1) The Small AquaBasin
is designed with one
removable grate for
easy pump access.
Connect the tubing to
the Ultra
™
Pump and
ball valve using the plumbing supplies from the AquaBasin
#98136, #98138, or #98463 sold separately) and then place the pump and plumbing
™
inside the AquaBasin
out the notch on the side of the AquaBasin
™
2) The Small AquaBasin
each corner on top of the AquaBasin
additional option of placing a decorative piece on one of
the corners and running the tubing inside the basin rather
than through the center plumbing port. Depending what
size tubing is being used, a ½" or ¾" hole saw drill bit
will be needed to drill out the hole(s). (See the drawing
on the right.)
3) Next, carefully place the stone item where desired and feed
the tubing through the hole on the bottom of the fountain
and set upright. (*Note – It is recommended to adjust the
water flow of the pump by adjusting the ball valve before finally placing the stone piece
and covering the top with gravel.) (Fig. 8)
4) Now that everything is in place, you can finish covering the top with your choice of gravel.
Fig. 6
. The cord from the pump can be run
™
. (Fig. 6 & 7)
is designed with a drill point in
™
. This gives you the
™
™
Ultra
Pump Kit (items
Optional
4 Drill Points
Fig. 7
Center
Plumbing Port
Fig. 8
3
Advertisement
