Charging The Battery, Leds; Charging The Battery; State Of Charge; Leds On Battery - Stihl RMA 460 Instruction Manual

6 Charging the Battery, LEDs

► Remove the chute, @ 7.4.2.
► Remove the grass box, @ 7.2.2.
► Fit the mulch plug, @ 7.3.1.
► Adjust cutting height, @ 13.2.
► Check the controls, @ 12.1.
► If 3 LEDs flash red while you are checking the controls:
Remove the activation key and battery, and contact
your STIHL servicing dealer for assistance.
There is a malfunction in the mower.
► If you cannot carry out these steps: Do not use your
mower and contact your STIHL servicing dealer for
assistance.
6 Charging the Battery, LEDs
6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see
www.stihl.com/charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2

State of Charge

1
0458-796-9921-B
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3
The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 20.1.
There is a malfunction in the mower or battery.

7 Assembling the Lawn Mower

7.1
► Switch the lawn mower off, pull out the activation key and
remove the battery.
► Place the lawn mower on a level surface.
7
8
80-100%
60-80%
40-60%
20-40%
► Align upper handlebar (1) and lower handlebar (2) so
stud (4) engages in bore (3) on both sides.
0-20%
► Insert bolt (5) and align so the bolt head is flush with lower
handlebar (2) on both sides.
► Screw on star grip nut (6).
► Press cable (7) into holder (8).

LEDs on Battery

Attaching the Handlebar

1
English
2
2
5
4
6
3
1
13