Types Of Work - Hilti TE 6-CL Original Operating Instructions

7

Types of work

WARNING
Damaged power cords are a safety hazard! If the supply cord or extension
cord is damaged while work is in progress, immediately disconnect the
device and the cord from the electricity supply. Do not touch the damaged
part of the cord.
▶ Regularly check all supply cords. Replace defective extension cords.
Have damaged power cords replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a
maximum tripping current of 30 mA is recommended.
7.1 Forward / reverse
▶ Set the forward / reverse selector switch to forward or reverse rotation.
7.2 Drilling without hammering
▶ Set the function selector switch to the "Drilling without hammering"
position .
7.3 Drilling with hammer action (hammer drilling)
▶ Set the function selector switch to the "Hammer drilling" position
7.4 Chisel positioning
▶ Set the function selector switch to the "Chisel positioning" position
▶ The chisel can be adjusted to 18 different positions (in 20° increments).
This ensures that flat chisels and shaped chisels can always be set to
the optimum working position.
7.5 Chiseling 6
CAUTION
Risk of injury Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel
positioning". Turn the function selector switch until it engages in the
"Chiseling"
▶ Set the function selector switch to the "Chiseling" position
7.6 Removing the accessory tool
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
1. Pull the accessory tool retaining bar back as far as it will go.
10 English
5
6
position.
6
4
2266071
6
.
.
*2266071*
.