After hanging the hood on the bracket , remove the Alu Filters , mark 2 holes
After hanging the hood on the bracket, remove the grease filters, mark 2 holes inside the hood for
inside the hood for safety screws .After marking , remove the hood ,drill two holes
safety screws. After marking, remove the hood, drill two holes and insert 2 wall plugs and finally
and insert 2 pcs of Wall Plugs and finally fix the safety screws with
fix the safety screws with 2 screws (ST4x30mm).
2 screws ST4x30mm.
Exhaust pipe
ker hood
Fix the one-way-valve to the air outlet of the cooker hood. Then, attach the exhaust
Fix the one-way-valve to the air outlet of the cooker hood. Then, attach the exhaust pipe onto the
pipe onto the one-way-valve as shown below.
one-way-valve as shown below.
Exhaust pipe
Exhaust Pipe
Exhaust pipe
Cooker hood
Cooker hood
Cooker Hood
Chimney installation.
Place the upper chimney into lower chimney,Use 2 pcs ST4x8mm screws to attach
C H I M N E Y I N S TA L L AT I O N
lower and upper chimney together.
Place the upper chimney into lower chimney, use 2 pcs ST4x8mm screws to attach lower and
Before attaching the bracket to the chimney,decide the location of lower
upper chimney together.
chimney bracket fixing holes for fixing the lower chimney bracket in the later steps.
Before attaching the bracket to the chimney, decide the location of lower chimney bracket fixing
Noted: Do not fasten screws too much, make sure upper chimney can be
holes for fixing the lower chimney bracket in the later steps.
telescopically adjusted after assembled.
N OT E :
Do not fasten screws too much, make sure upper chimney can be telescopically adjusted after
assembled.
Please keep this instruction manual for future reference
12
Instruction manual CCH
12
Instruction manual CCH
6
6
Please keep this instruction manual for future reference