Lancom R&S Unified AGPO150 Migration Manual page 10

Upgrading the LANCOM R&S
versions 9.6 and 9.8
6
If the upgrade process is interrupted, the LANCOM R&S
Firewall can be damaged. Do not power off the device during
the upgrade process. Only restart the device if you are explicitly
requested to do so.
A If you are upgrading the LANCOM R&S
9.8, configure the external access to the Web client in advance
("Settings > Firewall > Security > Access").
A If you are using a device with less than 4 GB memory, disable the UTM
settings. Otherwise, the upgrade may fail.
A In the gateprotect administration client, open the update manager
("Settings > Updates").
A Select "Upgrade from v9.x to 10.4".
Tip: If the upgrade is not listed, click on "Refresh".
Note: Before upgrading, all patches have to be installed. To install some
patches, the LANCOM R&S
You can find out whether a restart is necessary in the description of the
respective patches.
A Click on "Install".
A The upgrade is downloaded automatically.
A The LANCOM R&S
complete.
Note: Depending on the device type, the integrity check of the upgrade
can take some time.
The LANCOM R&S
Note: The installation can take up to 30 minutes.
After the installation, the LANCOM R&S
automatically.
A Close the gateprotect administration client.
9
LANCOM Installation Guide – Upgrade procedure
Unified Firewall may have to be restarted.
®
Unified Firewall restarts after the download is
®
Unified Firewall installs the upgrade automatically.
®
Unified Firewall from
®
Unified Firewall from version
®
Unified Firewall restarts
®
Unified
®