Conceptronic CMED3PLUS Firmware Upgrade Instructions

Hide thumbs Also See for CMED3PLUS:

Advertisement

Conceptronic CMED3PLUS Firmware Upgrade Instructions
A. Upgrade information
The Conceptronic CMED3PLUS is equipped with an upgradeable firmware chip. This function makes it
possible to improve the device and to add new features.
Note: This firmware upgrade for the CMED3PLUS can only be applied to devices with firmware version
1.54 (MP07T022408A) or higher. If you have a lower version you need to upgrade to version
1.54 before you can apply this firmware upgrade.
Note: The firmware upgrade procedure is at your own risk. Even though a firmware upgrade can
improve the device and add new features, there's also a possibility of an upgrade failure which
makes the device unusable. Conceptronic is not responsible for this and this voids the warranty.
for firmware version: 1.54B / MP07T031408A
®
Copyright
2007 by Conceptronic – All rights reserved
www.conceptronic.net
Page 1 of 7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CMED3PLUS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Conceptronic CMED3PLUS

  • Page 1 Note: This firmware upgrade for the CMED3PLUS can only be applied to devices with firmware version 1.54 (MP07T022408A) or higher. If you have a lower version you need to upgrade to version 1.54 before you can apply this firmware upgrade.
  • Page 2 B. WARNING !!! There are two different versions of the Conceptronic Media Player on the market. Both versions only differ in hard disk connection type (SATA vs. IDE) and the supplied remote control. Since the devices are so similar it is mandatory to pick out the right product when upgrading the firmware. The easiest way to identify your Media Player is through the remote control.
  • Page 3 1.3 Copy the ‘FW’ folder including all its content to the hard disk of the CMED3PLUS. 1.4 Remove the CMED3PLUS from your computer with the ‘Safely remove hardware’ option. 1.5 Disconnect the USB cable of the CMED3PLUS and turn it off with the switch on the back side. 2. Updating the firmware 2.1 Connect the CMED3PLUS to a TV or monitor.
  • Page 4 2.1 Make sure the CMED3PLUS is connected to a TV or monitor. 2.2 Turn on the CMED3PLUS with the remote control. 2.3 Connect the USB stick to the CMED3PLUS or slide the memory card in the right card slot of the CMED3PLUS.
  • Page 5 3. Checking the firmware version 3.1 Make sure the CMED3PLUS is connected to a TV or monitor. 3.2 Select a folder by using the navigation buttons on the remote control. 3.3 Press the ‘FUNC’ button on the remote control, select ‘PROPERTIES’ and press the ‘Enter’...
  • Page 6 - Problem with the default PAL setting is solved. MP07T092106A: - Auto start function added. - Some minor internal changes. - DVD menu navigation support added (see chapter G for an explanation). ® Copyright 2007 by Conceptronic – All rights reserved www.conceptronic.net Page 6 of 7...
  • Page 7 To playback a DVD with menu navigation, you need to do the following: 1. Copy all files from the DVD to a folder on the hard disk of the CMED3PLUS. The name of the folder can be anything (for example: ‘DVD_DISC1’). The DVD folder structure however, has to be maintained.

Table of Contents